三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

en overcurrent which exceeds the rating or caused by short-circuited load flows in the output
module for a long time, it may cause smoke or fire. To prevent this, configure an external safety
circuit, such as fuse.
• Build a circuit that turns on the external power supply when the PLC main module power is
turned on. If the external power supply is turned on first, it could result in erroneous output or
erroneous operation.
• When there are communication problems with the data link, refer to the corresponding data link
manual for the operating status of each station.
Not doing so could result in erroneous output or erroneous operation.
• When connecting a peripheral device to the CPU module or connecting a personal computer or
the like to the intelligent function module to exercise control (data change) on the running PLC,
configure up an interlock circuit in the sequence program to ensure that the whole system will
always operate safely.
Also before exercising other control (program change, operating status change (status control))
on the running PLC, read the manual carefully and fully confirm safety.
Especially for the above control on the remote PLC from an external device, an immediate
action may not be taken for PLC trouble due to a data communication fault.
In addition to configuring up the interlock circuit in the sequence program, corrective and other
actions to be taken as a system for the occurrence of a data com
定位模塊模塊 AJ65BT-D75P2-S3
CPU組件 A2SHCPU
輸出模塊 AY41P
伺服馬達 HF-MP73
內置RS232C接口的CPU組件 A1SCPUC24-R2
過程CPU Q12PHCPU，Q25PHCPU
伺服馬達 HF-SP52
電源連接器 MR-PWCNK2
性能型CPU Q02CPU，Q06HCPU，Q25HCPU
伺服電機電源用電纜 MR-PWS1CBL2M-A2-L
保護膜 GT10-40PSGB
CPU單元 A3ACPUP21
RS-422電纜 GT10-C30R4-8P
電源模塊 A68P
外部連接電纜 GT16H-C50-32P
耐油蓋 GT05-50PCO
RS-422電纜 GT10-C300R4-25P
電源模塊 A0J2PW-DC24V
RS-422電纜 GT01-C300R4-8P
過程CPU Q12PHCPU
FA設備連接繼電器電纜 GT11H-C80-32P
CPU單元 A2CJCPU-S3
輸出模塊 AY82EP
電源模塊 A2CJ66P
CON2接頭 MR-J2CMP2
CPU單元 A2CCPUR21
網絡模塊 AJ71QLP21S
伺服電機電源用電纜 MR-PWS1CBL5M-A2-H
繼電器輸出模塊 AJ35PTF-24R
存儲卡 FX-EEPROM-8