三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

module, performing wiring work, or inspections. Failing to do so may lead to electric shocks.
When performing wiring work or inspections, turn the power OFF, wait at least ten minutes, and
then check the voltage with a tester, etc.. Failing to do so may lead to electric shocks.
Be sure to ground the Motion controller, servo amplifier and servomotor. (Ground resistance :
100 or less) Do not ground commonly with other devices.
The wiring work and inspections must be done by a qualified technician.
Wire the units after installing the Motion controller, servo amplifier and servomotor. Failing to do
so may lead to electric shocks or damage.
Never operate the switches with wet hands, as this may lead to electric shocks.
Do not damage, apply excessive stress, place heavy things on or sandwich the cables, as this
may lead to electric shocks.
Do not touch the Motion controller, servo amplifier or servomotor terminal blocks while the power
is ON, as this may lead to electric shocks.
Do not touch the built-in power supply, built-in grounding or signal wires of the Motion controller
and servo amplifier, as this may lead to electric shocks.
伺服馬達 HA-LFS701M4
伺服放大器 MR-J2S-70A
伺服電機電源用電纜 MR-PWS2CBL03M-A2-L
PLC FX1S-10MR-D
DC 輸入模塊 AJ65SBTCF1-32D
變頻器 FR-F740-S110K-CHT
PLC FX3G-40MR/ES-A
伺服馬達 HA-LFS601B
CPU單元 A2ACPUP21-S4
伺服電機 HC-KFS13BD
PLC FX1S-14MR-ES/UL
彈簧夾端子臺 Q6TE-18S
保護膜 GT16-60PSGB
輸入模塊 A1SX10
伺服馬達 HA-LFS30K1M4
定位模塊模塊 AJ65BT-D75P2-S3
伺服電機 HC-RFS353
可控硅輸出模塊 AJ35PJ-8S2
保護膜 GT15-90PSCB
PLC FX3U-16MT/DS
伺服控制器 MR-J2S-700A
DC 輸入/晶體管輸出模塊 AJ65SBTB1-32DT1
伺服馬達 HC-RFS103B
保護膜 GT16-70PSCB
PLC FX1S-14MT-DSS
智能通信模塊 AD51H-S3
CPU單元 A2ACPUP21-S3
伺服電機 HC-SFS1024
直流源型輸入模塊 A1SX80-S1
變頻器 FR-F740-S185K-CHT