三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

7
(1) For 2-wire transmitter input
(2) For current input
*1 Use a 2-core twisted shielded wire for the power wire.
*2 Shows input resistance.
*3 To connect with the 2-wire transmitter, be sure to connect to P and I+/CHK+.
*4 Always use a ground. In addition, ground the FG of the power supply module.
*5 The check terminals (CHK+, CHK-) are used to check the amount of input in
mA in relation to the 2-wire transmitter output.
This can be checked since analog inputs of 4 to 20mA are converted to analog
outputs of 1 to 5V.
The relationship of this conversion can be expressed by the following formula:
IMPORTANT
Q66AD-DG needs to be powered on 30 minutes prior to operation for compliance
to the specification (accuracy).
Therefore, power on 30 minutes prior to offset/gain setting or after online module
change.
P
I+/CHK+
I-/CHK-
24V
24G
Transmitter
power
supply
Modulator Demodulator
Current
limiting
circuit
*2
250
*1 Shielded
*4
Analog output(V)
Analog input(mA)
1000
250

電流輸出模擬量模塊 Q68DAIN
模塊 AJ35PTC-CNV-GI
外部輸入/輸出單元 GT15-DIOR
中斷模塊 AI61
模塊 AD32ID2
中斷模塊 QI60
電流輸入模擬量模塊 Q68ADI
適配器 Q6DIN3
模塊 A1SD35ID2
AS-I主站模塊 FX2N-32ASI-M
模擬量輸入模塊 Q68ADV，Q68ADI
模塊 AJ35PTC-CNV-SI
模塊 A1SD32ID1
轉(zhuǎn)換適配器 FX2NC-CNV-IF
適配器 Q6DIN1A
模塊 AD35ID1
模擬量模塊 AJ65BT-64DAI
中繼模塊 AJ65BT-RPI-10A
仿真單元 A6SIM-X64Y64
轉(zhuǎn)換電纜 FX2N-CNV-IF
模塊 AJ35PTC-CNV-SI
中繼模塊 AJ65BT-RPI-10B
模塊 AD32ID1
模塊 AJ35PP-CNV-SI
模塊 AJ35PP-CNV-GI
模擬量輸出模塊 A616DAI
模塊 AJ35PTC-CNV-GI
速中斷模塊 A1SI61
中斷模塊 AI61-S1
模擬量輸出模塊 A68DAI-S1