三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

Never run the unit with the front case or term inal cover removed. The high voltage terminal and
charged sections will be exposed and may lead to electric shocks.
Never open the front case or terminal cover at times other than wiring work or periodic
inspections even if the power is OFF. The insides of the Motion controller and servo amplifier are
charged and may lead to electric shocks.
When performing wiring work or inspections, turn the power OFF, wait at least ten minutes, and
then check the voltage with a tester, etc.. Faili ng to do so may lead to electric shocks.
Be sure to ground the Motion controller, servo amplifier and servomotor. (Ground resistance :
100 or less) Do not ground commonly with other devices.
The wiring work and inspections must be done by a qualified technician.
Wire the units after installing the Motion controller, servo amplifier and servomotor. Failing to do
so may lead to electric shocks or damage.
Never operate the switches with wet hands, as this may lead to electric shocks.
Do not damage, apply excessive stress, place heav y things on or sandwich the cables, as this
may lead to electric shocks.
Do not touch the Motion controller, servo amplifier or servomotor terminal blocks while the power
is ON, as this may lead to electric shocks.
Do not touch the built-in power supply, built-i n grounding or signal wires of the Motion controller
and servo amplifier, as this may lead to electric shocks.
CPU單元 A3NCPUR21
保護膜 GT10-30PSGB
性能型QCPU Q12HCPU
帶以太網類型的Q系列CPU Q04UDEHCPU
保護膜 GT15-50PSCW
伺服馬達 HF-KP13
CPU單元 Q2ASCPU-S1
網絡模塊 A1SJ71QLP21S
保護膜 GT15-70PSGW
中繼模塊 AJ65BTS-RPH
伺服馬達 HF-SP121B
模塊 AJ35PTC-CNV-SI
保護膜 GT10-50PSGB
伺服馬達 HF-KP23B
RS-422電纜 GT10-C30R4-25P
外部連接電纜 GT16H-C50-32P
C語言的控制單元 Q06CCPU-V
保護膜 GT15-60PSCW
模塊 AJ35TP-BU
輸出模塊 AY80EP
保護膜 GT16-80PSCB
Melsecnet接口模塊 A1SJ71AP21GE
RS-422電纜 GT01-C200R4-25P
伺服馬達 HF-MP053
基本型QCPU Q00CPU
FA設備連接繼電器電纜 GT11H-C130-32P
脈沖捕捉模塊 A1SP60
CON2接頭 MR-J2CMP2
FA設備連接繼電器電纜 GT11H-C15R4-8P
伺服電機電源用電纜 MR-PWS1CBL2M-A1-L