三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

WARNING
. Items related to operation
If the operation start position is set in a block which is in the middle of the program and the
program is started, the program before the set block is not executed. Please confirm that G
and F modal and coordinate values are appropriate. If there are coordinate system shift
commands or M, S, T and B commands before the block set as the start position, carry out
the required commands using the MDI, etc. If the program is run from the set block without
carrying out these operations, there is a danger of interference with the machine or of
machine operation at an unexpected speed, which may result in breakage of tools or
machine tool or may cause damage to the operators.

Under the constant surface speed control (during G96 modal), if the axis targeted for the
constant surface speed control moves toward the spindle center, the spindle rotation
speed will increase and may exceed the allowable speed of the workpiece or chuck, etc. In
this case, the workpiece, etc. may jump out during machining, which may result in
breakage of tools or machine tool or may cause damage to the operators.
電磁制動器用電纜 MR-BKS1CBL10M-A1-L
RGB輸出單元 GT16M-ROUT
GT16觸摸屏 GT1665M-STBA
PLC FX1S-30MT-DSS
編碼器電纜 MR-ENCBL5M-H
PLC FX3U-64MR/DS
PLC FX1N-24MR-ES/UL
伺服放大器 MR-J3-100A
Q系列編程器ATA卡 Q2MEM-8MBA
伺服電機 HC-MFS23
PLC FX2N-16MR-D
伺服放大器 MR-J3-40A
電磁制動器用電纜 MR-BKS1CBL2M-A1-L
電磁制動器用電纜 MR-BKS2CBL03M-A2-L
伺服放大器 MR-J3-20B
電磁制動器用電纜 MR-BKS1CBL5M-A2-H
顯示模塊 FX3U-7DM
PLC FX1N-40MR-ES/UL
定位控制模塊 A1SD75M1
PLC FX1S-14MT-ES/UL
伺服控制器 MR-J2S-700A
對應SSCNET III定位模塊 QD75MH1
PLC FX2N-64MR-DS
伺服控制器 MR-J2S-15KB
PLC FX2NC-32MT-DSS
伺服馬達 HA-LFS11K1M4
PLC FX2N-16MT-DSS
編碼器電纜 MR-JCCBL10M-L
PLC FX2N-80MT-ESS/UL
伺服電機 HC-MFS053