三菱PLC，三菱变频器，三菱伺服，三菱电机--广州凌控

1. Items related to product and manual
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by
the machine tool builder takes precedence over this manual.
Items not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all optional functions are added. Confirm the specifications
issued by the machine tool builder before use.
Some screens and functions may differ or may not be usable depending on the NC system version.
2. Items related to connection
When using an inductive load such as relays, always contact a diode in parallel to the load as a noise
measure.
When using a capacitive load such as a lamp, always connect a protective resistor serially to the load to
suppress rush currents.
Since the analog output R registers are allocated in ascending order of channels and station numbers, the
analog output destination may change depending on added option.
3. Items related to design
Always turn the spindle phase synchronization completion signal ON before chucking both ends of the
workpiece to the basic spindle and synchronous spindle. If the spindle phase synchronization signal is
turned ON when both ends of the workpiece are chucked to the basic spindle and synchronous spindle, the
chuck or workpiece could be damaged by the torsion that occurs during phase alignment.
CAUTION
CN4電纜 MR-H3CBL1M
伺服放大器 MR-J3-70A
伺服放大器 MR-J2S-350B4
伺服馬達 HF-MP13
伺服電機電源用電纜 MR-PWS1CBL5M-A2-H
伺服馬達 HF-MP23
PLC FX1N-40MR-001
PLC FX1N-60MR-D
PLC FX2N-32MR-D
附件 MR-J2HBUS05M
PLC FX3G-14MT/ESS
編碼器用電纜 MR-ENECBL2M-H
模擬量輸入模塊 AJ35T-M08B-L
伺服驅動器 MR-J2S-37KB4
PLC FX1S-10MT-DSS
編碼器電纜 MR-ENCBL5M-H
Q系列PLC存儲卡用適配器 Q2MEM-ADP
控制器放大器總線電纜 MR-J2CN1-A
PLC FX1N-60MT-D
伺服電機 HC-MFS23BK
電磁制動器用電纜 MR-BKS1CBL10M-A1-L
個人電腦通信電纜 MR-JRPCATCBL3M
CF卡 GT05-MEM-4GC
PLC FX2NC-32MT-D/UL
可選功能板 GT15-QFNB16M
可編程控制器 FX1N-24MR-001
GT16觸摸屏 GT1675M-VTBD
PLC FX2N-128MR-001
PLC FX1S-14MR-ES/UL
嵌入型I/O模塊 AJ65MBTL1N-16DT